To print a snapshot of Control‑O internal data areas, issue operator command
F CONTROLO,SNAP[=name1,name2 .....,namen] |
where name1, name2,.... namen are the names of the Control‑O internal data areas.
When no name is specified, all data areas are printed. Your BMC Customer Support can provide you with the list of data area names, and can specify which areas must be printed depending on the problem encountered.
Table 197 Valid Values for Data Areas
Value |
Value |
Value |
Value |
Value |
Value |
Value |
---|---|---|---|---|---|---|
ALL |
DLY |
MTOLNK |
MTOWSC |
RQCALO |
RQCSTO |
STO |
ALO |
EXO |
MTOMIX |
MVS |
RQCDLY |
RQH |
SWT |
CAS |
LINK |
MTOMPT |
OMT |
RQCEXO |
RULES |
SYS |
CDT |
MAIN |
MTOPLB |
OPR |
RQCFREE |
SEC |
UCM |
CONLIST |
MCT |
MTOPND |
PARM |
RQCMTO |
SLO |
VARS |
CONS |
MTO |
MTOPNX |
PND |
RQCRFR |
SRV |
WISHES |
CONSOLE |
MTOCOS |
MTOSRV |
RFR |
RQCSLO |
SSCT |
WSC |
COS |
MTOINX |
MTOSRVA |
RQC |
RQCSRV |
SSVT |
|
When the snap is completed, the following message is displayed on the console:
CTO150I SNAP COMMAND WAS PERFORMED SNAPID=xxxx |
where xxxx is the snap identifying number (SNAPID) that is displayed at the lower right of the screen after the snap is completed.
Parent Topic |