The Dynamic Destination table is loaded when the respective INCONTROL product monitor is started. To replace the current Dynamic Destination table with a new one, use the appropriate operator command for each INCONTROL product installed at your site, as described in the following table:
Table 53 Operator Commands for Replacing the Dynamic Destination member
Command Syntax |
Product |
---|---|
F CONTROLM,NEWDEST |
Control‑M |
F CONTROLD,NEWDEST |
Control‑D |
F CONTROLO,NEWDEST |
Control‑O |
F IOAFMON,NEWDEST |
The IOA Functional monitor used by Control‑M/Tape |
The IOADEST table is reloaded and an accompanying message is displayed on the operator console from which the modify command was issued, when the monitor resumes job processing.
Parent Topic |