Step 7: Define Vaults

Verify that the Vault Definition Table member is specified in DD statement DAVLTS in procedure CTTINIT.

This member is defined to CTTINIT during Control-M/Tape installation.

The default name for the Vault Definition Table member is $$VAULT, and it is stored in the Control-M/Tape PARM library.

To define vaults to Control-M/Tape to match the vaults that are defined to ASG-Zara

1. Enter the Control-M/Tape Vault Definition screen (TV).
2. Select the member that was allocated for vault definitions during Control-M/Tape installation.

   The default name is $$VAULT, stored in the Control-M/Tape PARM library.

3. Define all the vaults the same way that they are defined to ASG-Zara.

   If capacity is not specified for a vault, Control-M/Tape Slot Management will not be active for that vault.