Pool Definition Entry Panel

Figure 27 Pool Definition Entry Panel

------------------ CONTROL-M/Tape POOL DEFINITION ENTRY PANEL -------------(TP)

COMMAND ===>                                                                  

SPECIFY LIBRARY, TABLE NAME, POOL NAME                                       

  LIBRARY   ===> CTTP.PROD.PARM                                                

  TABLE     ===>                      (Blank for table selection list)         

  POOL      ===>                      (Blank for pool selection list)         

USE THE COMMAND "SHPF" TO SEE PFK ASSIGNMENT                           14.34.11

Note: If you use the selection list fields, their values are not erased until you exit the entry panel by pressing END (PF03/PF15).

To open the desired display

Fill in entry panel fields LIBRARY, TABLE, and POOL as described below to open the desired display.   

To display the list of tables in a library

1. Type the library name.
2. Either leave the table name blank, or type part of a table name together with mask characters (* and ?).
3. Press Enter.

To display the list of rules of a specific pool

1. Type the library name.
2. Type the table name.
3. Press Enter.

If the table does not exist, the screen for defining a new pool in the table is displayed.

To display the details of a specific pool (Pool Definition screen)

1. Type the library name.
2. Type the table name.
3. Type the pool name.
4. Press Enter.

If the table does not exist, or if the pool for the specified table does not exist, the screen for defining a new pool in the table is displayed.

Note: If you enter the screen for defining a new pool and want to leave the screen without defining a pool, use the CANCEL command.