Displaying a Control-O Storage Table

To obtain information about Control‑O usage of internal storage areas, issue operator command

Note: Only issue this command if requested by your BMC Customer Support representative.

Information message CTO356I is issued in response to this command. The figure shows an example of this message.

Figure 69 Information Message CTO356I Example

CTO356I STORAGETABLE

   NAME         ADDRESS  LEN(HEX)  LEN(DEC)

   DEST         00D495C8 00000108  00000264

   FMIX         00000000 00000000  00000000

   INX          0370A390 000000E8  00000232

   MIX          036C0D28 00000504  00001284

   MSGB         00045190 00018E70  00102000

   PND          0358BAC8 00021534  00136500

   SRVR         03673EB8 00001144  00004420

   WSC          03614000 0001E000  00122880

   NETMAP      00C014A0 00003B60  00015200

   CTOWTO       831B3600 0002AA10  00174608 12/21/00 16.56 BO0709

   CTOAIDT      00BA6D58 000082B8  00033464 12/06/00 12.18 WO0818

   CTOALT       80B8FEC0 00003140  00012608 11/16/00 12.37

   CTOMTO       00006FB0 0003E050  00254032 01/09/01 13.15

For more information about these messages, see the INCONTROL for z/OS Messages Manual.

Control‑O users can tune the PND and WSC by adjusting the values of the WAITPR# and WSCs# parameters in the CTOPARM member. However, the RQC cannot be tuned. Look for any PTFs that correct problems handling RQC.