Set the level for an external Load-Index

The LOAD-INDEX SET command (or LIND SET command) sets a load level value for an external Load-Index.

Use the following API command:

LOAD-INDEX SET,parameters

The following parameters can be used in this command:

Table 273c Parameters of the LOAD-INDEX SET command

Parameter	Description
NAME	Name of Load-Index to set. Masking is supported.
NEWLEVEL (or NEWLVL)	The new level to set for the Load-Index. Valid values: CRITICAL, V-HIGH, HIGH, MEDIUM, LOW, IDLE
ISOVERRIDDEN (or ISOVER)	(Optional) Perform the action depending on whether or not the load level of the Load-Index is currently overridden. Valid values: Y (Yes) \| N (No)
LEVEL (or LVL)	(Optional) Perform the action only if the current load level is as specified. Valid values: CRITICAL, V-HIGH, HIGH, MEDIUM, LOW, IDLE
FROMLEVEL (or FROMLVL)	(Optional) Perform the action only if the current load level is as specified or higher. Valid values: CRITICAL, V-HIGH, HIGH, MEDIUM, LOW, IDLE
NOTE	(Optional) Add a note to the action.

Parameter

Description

NAME

Name of Load-Index to set.

Masking is supported.

NEWLEVEL

(or NEWLVL)

The new level to set for the Load-Index.

Valid values: CRITICAL, V-HIGH, HIGH, MEDIUM, LOW, IDLE

ISOVERRIDDEN

(or ISOVER)

(Optional) Perform the action depending on whether or not the load level of the Load-Index is currently overridden.

Valid values: Y (Yes) | N (No)

LEVEL

(or LVL)

(Optional) Perform the action only if the current load level is as specified.

Valid values: CRITICAL, V-HIGH, HIGH, MEDIUM, LOW, IDLE

FROMLEVEL

(or FROMLVL)

(Optional) Perform the action only if the current load level is as specified or higher.

Valid values: CRITICAL, V-HIGH, HIGH, MEDIUM, LOW, IDLE

NOTE

(Optional) Add a note to the action.

Example:

Command:

LOAD-INDEX SET NAME=* NEWLEVEL=HIGH

Response:

WLI031I LOAD-INDEX LINDEX2 WAS SET TO LEVEL HIGH

WLI035W LOAD-INDEX LINDEX3 NOT EXTERNAL, SKIPPED

WLI03BI ACTION PERFORMED WITH WARNING, 1 LOAD-INDEXES MODIFIED