Configuring Control-M for PeopleSoft settings

This procedure describes how to configure Control-M for PeopleSoft settings through the configuration management utility.

To configure Control-M for PeopleSoft settings:

1. From the CCM, select Control-M for PeopleSoft, right-click and select Configuration Management.

   The Control-M for PeopleSoft Configuration Management dialog box appears.

2. Change the configuration parameters as required, which are described in Configuration parameters.
3. Select Debug Tracing, if debugging needs to be traced.
4. Select Validate Run Control, if you require run control to exist during job submission.
5. Click OK.
6. If any of the parameters change, you may be prompted to recycle Control-M for PeopleSoft. If so, a Configuration Management dialog box appears.

   If you do not recycle at this stage, you need to shut down manually, as described in Shutting down Control-M for PeopleSoft.

7. Click Yes.

   A Control-M for PeopleSoft dialog box appears, which confirms that the recycle request completed successfully.